The Scion FR-S coupe, intended for the US and Canadian markets, is a replica of the Toyota GT 86 / Subaru BRZ.
Scion FR-S has been produced since 2012 in Japan.
Unlike its brethren, the Scion FR-S has no equipment levels. He has one standard piece of equipment, initially quite rich. However, some things are still offered as options.
2012 2013 2014 2015 2016 Scion FR-S Engine Oil Capacity
| Engine | Engine Oil Capacity (with filter) | Oil type (viscosity grade) |
| 2.0L 4-cyl Engine FA20 | 5.4 liters (5.7 quarts) | 0W-20 |
0W-20 is the best choice for good fuel economy and starting in cold weather. If 0W-20 is not available 5W-20 may be used. However, it must be replaced with 0W-20 at the next oil change.
2021 2022 Scion FR-S Engine Oil Capacity
| Engine | Engine Oil Capacity (with filter) | Oil type (viscosity grade) |
| 2.4 L FA24 H4 | 4.6 liters (4.8 quarts) | 0W-20 |
The FR-S is built on a platform that, prior to modification, was used as the basis for the Subaru Impreza.
How Much Oil Does Scion FR-S Take?
The Scion FR-S has a 2.0-liter engine; the Engine Oil Capacity is 5.7 quarts with a filter. The recommended oil type is 0W-20 synthetic.
What Kind Of Oil Does A Scion FR-S Take?
The Scion FR-S takes 0W-20 synthetic oil. This is the recommended oil type by Scion for optimal engine performance.
Scion FR-S Oil Change Interval
The oil change interval for the Scion FR-S is 7,500 miles or 6 months, whichever comes first.
How To Check The Oil Level In A Scion FR-S
The oil level in the Scion FR-S can be checked by using the dipstick. The oil dipstick is located on the driver’s side of the engine, near the front of the car. Pull out the dipstick and wipe it clean with a rag to check the oil level. Insert the dipstick back into the engine and then pull it out again to check the oil level. The oil level should be between the “full” and “add” marks on the dipstick. If it is below the “add” mark, then you will need to add oil to the engine.
How To Add Oil To A Scion FR-S
Adding oil to the Scion FR-S is a simple process. First, locate the oil fill cap on the driver’s side of the engine. Then, unscrew the oil fill cap and add oil to the engine until it reaches the “full” mark on the dipstick. Screw the oil fill cap back on, and you are finished.
